Pot in a Pot 2

It was 2 days later that I got back to my pot. After some preliminary rolling in the dryer, I rolled it by hand.

It shrank quite a lot. it is very tight around the resist. It is time to do some cutting. I cut in the spaces between the fins.

You can see how much the hole grows as you work the edge. The little blob on the left is the piece I cut out.

I didn’t want to pull the resist out through the hole. It is bulkier and less flexible than usual with the duct tape holding on the fins. I cut an X in the bottom of the outside pot. If I had thought about it I would have done it in the bottom of the inside pot so no one would ever have seen it.

This is how much it has shrunk so far.

Next was a vigorous rub down with a rubbing tool. This is one Jan found in the pet section of our Dollar store. It’s for washing your very dirty dog. I covered the pot with some plastic before rubbing. It is too grabby to use directly on the felt.

l

It shrank a little more but now it is al flat and smooth.

Before doing any more I needed to rinse out the soap. It always takes much longer to get all the soap out than I think it should.

I start with hot water and finish with cold. I also want to get more shrinkage during this prosses so I am quite aggressive in getting the water through felt to get the soap out.

This is how much more it shrank. You can see the black lines of where it was before rinsing.

I stuck the yellow inside the red one. It wasn’t too hard because the how where they are joined is not very small. What was harder was getting the ball in so I could blow it up. I wanted to use a ball because I didn’t think a balloon would be strong enough. I did get this one I but ended up taking it out and switching to a smaller 8-inch ball. the ball is a Linsom ball, they are nonslip, sort of sticky on the outside. They are great balls because they come with a removable plug. I took a vessel class with Sharon Costello where we used them. I suppose it helped the first layer of wool to stick. The layout on a ball is very difficult. It was a great class, a lot of fun and we learned a lot but not one I like to use.

and in the dark

I think it turned out fairly well. If I were to do it again I think I would make the inside pot bigger so it would open up the fins. I may, depending on how ambitious I am, wet it down, blow up a ball inside and them stuff plastic bags in to make the outer pot bigger. I may cut the fins off and then so some stretching so you can see more of the inside pot. I am still thinking. What would you do?